Modify a 1998 Chevrolet S10 Coil Pack
On a One thousand nine hundred ninety eight Chevrolet S-10, the ignition process is controlled by a coil pack that resides on the side of the engine. The coil pack controls the Glimmer going to Everyone cylinder, so provided one of the coils goes absent, you'll itch to alter it, or your engine Testament dart at a lesser energy whereas one fewer cylinder is firing. Avail a flat-head screwdriver to pull off the plastic tabs that secure the plastic inner fender liner to the fender, and locate that to the side.2. Marker Everyone spark-plug wire on the coil pack with the masking tape and permanent marker. Practise Everyone ticket has something that Testament corrective you know where the spark-plug wires commitment to be attached to the replacement coil pack.
Capitalization the jack to lift the front of the S-10, then fix it on the jack stands. Build undeniable the vehicle is completely and solidly on the stands before you job on the vehicle. Remove the Chauffeur's-side tire with the tire iron, and allot it to the side. Although it's a bit complicated to receive to the coil pack, it's not rigid to remove.
Instructions
1.For example, one label could read "top right coil," and another could read "bottom right coil," or whatever works for you. Then remove each spark-plug wire from the coil pack by gripping the base of the wire and pulling toward you with a twisting motion. Unplug the wiring harnesses at the same time.
3. Unbolt the coil pack from the side of the engine block, using the socket wrench, and discard the pack. Install the replacement coil pack onto the engine with the socket wrench, then push the spark-plug wires onto the coil pack, according to the labels you made. Reinstall any electrical connections at the same time.
4. Reinstall the fender liner by pushing in the plastic clips with your thumb. Then reinstall the driver's-side tire with the tire iron, and lower the truck off of the jack stands with the jack.
