Change One thousand nine hundred ninety nine VW Passat Rear Brakes
The rear brake pads on your 1999 Passat may want replacing approximately 15,000 miles from when they were carry on replaced. Replacing the rear brake pads Testament wish the fresh doctrine of adjust the parking brake cable to your Passat brake manner. A best brake caliper piston retracting stuff is required to perform this repair procedure Homewards.
Instructions
Replacing the Rear Brake Pads
1. Lift the Passat rear neb, and flotation it with jack stands. Remove the lug nuts, using a tire iron and wheels.
2. Disengage the parking brake, and adjust the parking brake cable, so that optimum for nothing play in the cables is allowed.
3. Use brake course cleaner over the brake components. Swab off the sprayed areas with a rag. Dawn with the brakes on one circle, while using the other as a reference.
4. Remove the caliper mounting bolts with a box wrench, while securing the propel pins with an open-end wrench from rotating.
5. Remove the caliper from the brake pads, and hang it from the shock absorber with a length of wire.
6. Pull elsewhere the brake pads from the caliper mounting bracket.
7. Remove the adviser pins absent of the boots, and study them for damage. Provided the pins are good, lubricate them with brake grease, and reinsert them.
8. Install a brake bleeding instruments to the bleed screw. Clear the bleed screw with a wrench.
9. Push the caliper piston into the caliper Muzzle, using a retraction stuff, turning the piston clockwise. Chance brake fluid should eject into the apparatus bottle as the piston retracts. When the piston has fully retracted, remove the tools, and tighten the bleed screw.
10. Install the new brake pads into the mounting bracket. Make sure the protective film on each pad, has been removed, before installing them.
11. Position the caliper back over the brake pads. Ensure that the anti-rattle springs are pressed against the inner surface of the caliper body.
12. Force the brake pads against rotors, by applying the brake pedal several times, until the pedal feels firm when depressed.15. Readjust the brake parking brake cables.16.
Install the new mounting bolts, and torque them to Twenty two ft-lbs. with your torque wrench, while keeping the guide pins from rotating with an open-end wrench.13. Repeat Step Three through Step Twelve to replace the other brake pads.14.
Install the wheels, and screw on the lug nuts with your fingers. Remove the jack stands, and lower the Passat. Torque the lug nuts with your torque wrench to Eighty nine ft-lbs.
17.Top off the brake fluid in the brake fluid reservoir, if necessary.
18. Test the new brakes, driving in an isolated area.
