The radiator on your 1997 Chevy Blazer is connected not alone to remainder of the engine cooling development however the transmission whether the vehicle is an automatic. This is the most recognizable Element of the cooling system and needs to be replaced whether the coolant is not properly flowing wrapped up it. You must alter this bite, when the engine is nipping, for the coolant within the action gets drastically blistering during accustomed development.
Instructions
Reconnect the negative battery cable with the wrench.
Cleared the radiator cap in the engine compartment--the engine must be coldish at this time--then remove the void plug at the the backside of the radiator. Remove the engine coolant into a ample container.
3. Remove the clamps from the upper air intake duct with a screwdriver and disconnect the duct from the air cleaner meeting.
4. Unscrew and remove the upper fan shroud with the screwdriver.
5. Disconnect the cooler lines from the radiator provided the Blazer has an automatic transmission and plug the lines with rubber plugs to prevent contamination. Disconnect both radiator hoses, loosening the clamps with the screwdriver.
6. Depress the plastic tabs for the lower fan shroud with a screwdriver to remove the shroud.
7. Pull the radiator up and elsewhere of the engine compartment.
Installation
8. Install the radiator into the engine compartment then the lower fan shroud, creation definite the shroud's tabs engage.
9. Reconnect the radiator hoses and cooling lines to the radiator. Moderate the hoses and clamps whether they are worn away in any way.
10. Reinstall the upper fan shroud and the air intake duct with their clamps/screws.
11. Refill the radiator with a fresh mix of water and antifreeze. Use the original coolant only if you are sure it is clean.
12.
